Appro SD-7800 Przewodnik Instalacji Pobierz pdf (Strona 10)

8 7800 Series Keypad Installation Guide

Installer Options Menu

Keypad Options and Keypad Diagnostic menus allow installing and service technicians to

congure and test keypad operation.

Access the Installer Options Menu

Access the Options menu through the carousel menu. While in the Option display, press the

Installer Options icon and enter the code 3577 (INST) at the keypad and press CMD.

The Options menu allows you to set the keypad address, select Supervised or Unsupervised

mode, selectively enable the Panic keys, Bypass, Request-to-Exit, and set entry

card options.

Note: All programming options display on all keypad models, however, actual operation for

some programming options is restricted to the appropriate model.

Programming Keypad Options

KPD KPD

OPT DIAG STOP

Keypad Options (KPD OPT)

To program keypad options, press KPD OPT.

CURRENT KEYPAD

ADDRESS: 01

Keypad Address

Set the keypad address from 01 to 08 with the XT30/XT50,

01 to 08 with the XR100 and XR150 Series, 01 to 16 with the

XR500 Series, and 01 to 16 with the XR350/XR550 Series.

The default address is set at 01. To change the current

address, press the address display and enter the new

address. It is not necessary to enter a leading zero for

addresses 01 to 09.

KEYPAD MODE:

SUP * UNSUP

Keypad Type

Congure the keypad for either Supervised or Unsupervised

operation. Keypads with zones connected to them must be

supervised and cannot share an address with other keypads.

Unsupervised keypads can operate together sharing the same

address. Zones cannot be used on unsupervised keypads.

To change the current setting, press the SUP or UNSUP. An

asterisk appears next to the selected option.

Note: Unsupervised addresses cannot be used when Device

Fail Output has a programmed value other than zero.

Default Keypad Message

Enter a custom message of up to 16 characters to appear on

the keypad display top line whenever that line is not used

for any other purpose. Press any Select area to clear the

current message and enter a new custom display.

ARM PANIC KEYS:

*PN *EM *FI

Arm Panic Keys

Use this option to congure the Panic Icons. To enable

or disable a Panic Icon, press the icon name: PN (Panic),

EM (Emergency), and FI (Fire). Once the panic icon is

enabled, an asterisk displays next to the description and the

respective Panic icons display for the user. Refer to the Panic

Icon Options section in this document.

DEFAULT KPD MSG:

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Komentarze do niniejszej Instrukcji

Brak uwag

Appro SD-7800 Przewodnik Instalacji Strona 10

Komentarze do niniejszej Instrukcji